• Login
    View Item 
    •   Mak IR Home
    • College of Natural Sciences (CoNAS)
    • School of Physical Sciences (Phys-Sciences)
    • School of Physical Sciences (Phys-Sciences) Collections
    • View Item
    •   Mak IR Home
    • College of Natural Sciences (CoNAS)
    • School of Physical Sciences (Phys-Sciences)
    • School of Physical Sciences (Phys-Sciences) Collections
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Thermal performance of an oil-rock heat storage system

    Thumbnail
    View/Open
    Masters Thesis (4.036Mb)
    Date
    2018-09
    Author
    Rukaaya, Musa
    Metadata
    Show full item record
    Abstract
    Experiments to evaluate the thermal performance of an oil-rock thermal energy storage system by direct heating from the base of the storage tank are presented. The oil-rock TES system consisted of a combination of sunflower oil and granite rocks. Results on thermal performance of an oil only TES system are also presented. Charging rates of the two TES systems using the thermosyphon principle were determined. An electrical heater was used to simulate solar radiation. In this case, AC power was used to test for the performance of the system in the laboratory and after testing its performance, it will be used with the solar concentrating systems for application. The performance parameters evaluated were: temperature distribution along the vertical height of the storage tank, thermal stratification, charging energy efficiency, energy stored, heat retention capacity, total exergy stored and exergy factors. The results indicate that not only the value of total energy stored and thermal stratification are important for thermal performance of a TES system but also the amount of total exergy stored should be considered. A high ratio of total exergy stored to total energy stored (Exergy factor) can be suggested as a good measure of thermal performance of the storage material. Charging a heat storage from the bottom resulted into loss of thermal stratification phenomenon all over the experiment. Results of charging the storage systems by thermosyphon principle indicated that the oil only TES charges for a shorter period than an oil-rock TES system. The boiler reached a temperature of 230°C in 82 minutes for oil-only TES and 98 minutes for oil-rock TES system and the corresponding maximum top temperatures attained were approximately 207°C and 222°C respectively. Generally, for both charging cases, the performance of the two TES systems was comparable. However, in terms of heat retention, the oil -rock TES retained more heat which makes it a more preferred TES medium
    URI
    http://hdl.handle.net/10570/7284
    Collections
    • School of Physical Sciences (Phys-Sciences) Collections

    DSpace 5.8 copyright © Makerere University 
    Contact Us | Send Feedback
    Theme by 
    Atmire NV
     

     

    Browse

    All of Mak IRCommunities & CollectionsTitlesAuthorsBy AdvisorBy Issue DateSubjectsBy TypeThis CollectionTitlesAuthorsBy AdvisorBy Issue DateSubjectsBy Type

    My Account

    LoginRegister

    Statistics

    Most Popular ItemsStatistics by CountryMost Popular Authors

    DSpace 5.8 copyright © Makerere University 
    Contact Us | Send Feedback
    Theme by 
    Atmire NV